CES-AH
Shop by BrandEUCHNER CES-AH Category 3 / PL d, Non-Contact Safety Switchers are used to monitor the position of movable machine guarding by means of Inductive Coding. These systems are designed for use in areas where a high level of tamper resistance and safety is required. These systems feature an inductive read head/ evaluation unit, and a digitally coded actuator. Unlike universally coded magnetic switches, the CES-AH actuators are uniquely coded and cannot be bypassed by any means. The CES-AH is an evaluation unit and read head in one featuring high current outputs.
Features
- Combination read head and evaluation unit
- Small design
- High current outputs
- Status LED’s
- Switch on distance up to 27 mm
- Safety category 3
- Unicode operation
>
Benefits
- Highest protection against tampering
- Short circuit detection by pulsed signals
- The safety system will enter a safe state even if an internal component fails
- Non-contact system
- Overcomes misalignment issues
- Vibration resistant
- Fault diagnostics
- Minimizes down-time
- Sensors operate thru stainless steel
- Food machinery, etc
- Long operational life
- Operates under extreme environmental conditions e.g. dirt, moisture, ambient temperature
Technical
- Up to safety category 3 PL d
- M23 9-pin connector
- Safety outputs directly switch up to 4 Amps
- Environmental Protection IP67 – oil and dust tight, and water resistant
- Ambient operating temperature -20 to 55C
- Operating voltage 20 to 28VDC
- Current consumption 150mA (no load)
- Safety output 30mA min, 4000mA max load
- Dimensions 40mm x 40 mm x 171 mm
No products were found matching your selection.