X402 Series
Shop by BrandSpecifications:
- EXP Housing: Hazardous Location, heavy gauge copper-free case aluminum
- Spin-off gasketed cover prevents propagation of internally generated arcs
- Stainless steel vent/drain
- Circuit board: silicone conformal coated
- Sealed test switch
- X402 Exit and Lamp Head fixture: heavy cast aluminum with pyrex lens
- Exit Faceplate: heavy-duty 20 gauge steel, baked enamel grey finish
- 6 inch EXIT lettering legend, available in Red or Green
- X402 AC-Only, AC/DC Exit Head, Surface Mount, ceiling, wall or pendant
- EXP Self-Powered Exit Sign Surface Wall Mount Only
- EXP Combination Unit Surface Wall Mount Only
- Self-Powered and Combination Housing includes (4) mounting lugs on each corner and 3/4 inch NPT conduit knock-outs entry on top and bottom of housing
- X402 & EXP single face model includes (1) faceplate
- X402 Double face model includes (2) faceplates
- Finished in industrial gray
- Faceplate includes two field-selectable, knock-out chevron indicators
- Manufactured in accordance with UL844, UL1203, and UL924
- Rated for operation in Class I, Division 1 & 2, Groups C and D
- Rated for operation in Class II, Division 1 & 2, Groups E, F and G
- Complies with NEC, OSHA and NEMA for above Classes and Groups
- Three-Year full warranty (subject to proper installation and maintenance)
- AC-Only Exit: Order X402 Exit Sign to be powered by a separate AC power source during emergency operation
- AC/DC Exit: Order X402 Exit Sign and a Transfer Switch Panel thus allowing for emergency operation to be supplied by a separate remote DC source
- Self-Powered Exit: Order EXP6N or EXP12N with attached X402 Exit Sign
- Combination Units: Order EXP6N or EXP12N, a E402 Light Head, and X402 Exit Sign
- (needed to be ordered separately with AC/DC Exit Signs)
- A TS panel is required for AC/DC Hazardous Location X402 Exit Signs that are under constant operation as required by code. TS panels are not designed to be installed/mounted in a hazardous or explosive area. TS panels are to be mounted remotely from these areas types.
- TS panel available for up to 6V= 50W, 12V= 100W, 24V= 100W
- To Order a TS Panel the following information is required:
- 1) AC Input. 120V and other voltages are available
- 2) DC voltage.
- 3) The total wattage load of all X402 lamp(s) to be supplied by TS Panel
- Electrical Specifications for the TS Panel
- Input AC voltage; 120V, 60Hz, 1 phase (other voltages available)
- Input DC voltage; 6, 12 or 24V (must select which applies)
- Input DC voltage must be identical to DC output voltage
- Wattage: TS Panel oversized 10-20% greater than total connected load
No products were found matching your selection.