None
A housing is not required for my application.
Type ARV, Series KTE1 Panel Arrays
A) The Number of Rows will determine the Housing Width. For overall width add 1.50″ (for the mounting lips).
B) The Number of Columns will determine the Housing Length. For overall length add 1.50″ (for the mounting lips).
Type ARV, Series KTE2 Panel Arrays
A) The Number of Rows will determine the Housing Width. For overall width add 1.50″ (for the mounting lips).
B) The Number of Columns will determine the Housing Length. For overall length add 1.50″ (for the mounting lips).
Type ARV, Series KTE6 & KTG6 Panel Arrays
A) The Number of Rows will determine the Housing Width. For overall width add 1.50″ (for the mounting lips).
B) The Number of Columns will determine the Housing Length. For overall length add 1.50″ (for the mounting lips).
Type CRA Linear Housing
Design Features
- Type KTE or KTG E-Mitters
- Extruded aluminum housing
- Series Elements pre-wired to terminal blocks
- Reflectors
- Fully assembled, ready to install, with mounting hardware
- 1/2″ trade size wiring entrance at both ends
- 40″ 1000 Watt CRA10025 shown above